Subject: Major Break through in rotary engine cooling.
From: ACRE
Date: 2/5/2004, 10:38 AM


Russell Kent wrote:

Paul,
Always understand what you are working with.  Read the MSDS:

http://www.uiowa.edu/~chemsafe/MSDS/EthyleneGlycol.htm

Possible problems:
1. PEG is very hydrophilic (it likes water).  It will absorb water
right out of the air, or
from any surface it touches (like your skin). Getting 100% pure PEG
into the block, and
*keeping* it 100% pure, might be a real challenge.  Plan on ending up
with 90 to 95% pure.

2. PEG can be absorbed through the skin.  Absorption rates are
proportional to
concentration.  Take protective measures when pouring PEG.

3. Breathing vaporized PEG is a very quick way to the hospital (or
morgue).  Be *VERY*
careful about high temperature venting of the cooling system (like
with a burst line).

Someone commented that elevated temps in the oil are a possibility.
I'd think that (in
addition to using full synthetic engine oil) a thermal barrier
coating on the rotor would
be a good idea.  The rotor faces aren't bearing surfaces, so
wear/galling isn't a problem
like with the housings.

Regards,
Russell Kent

When I advocated raising the boiling temp by increasing the pressure I
did
not get mass hysteria :)

95% would be fine. That would lower the freezing point to -20 and the
boiling point to 320 F. I am willing to bet that most cars running
around out there have all sorts of mixtures varying between 20% and
80%. People think nothing of adding pure water or pure ethylene glycol
when the coolant level is low. Rarely do they drain it all out and
replace it with the proper mixture. I also suspect that people having
trouble with their liquid cooled aircraft engine boiling over rarely
pay attention to the exact mixture ratio. I know Perry and I never
gave it a thought when we were trouble shooting his cooling system in
Palm Springs.

The world has been using ethylene glycol (Prestone) in their cars for
the last 70 years without a thought of the hazards. I have never heard
about anyone being harmed by it.
I have had it on my hands many times. I have even tasted it and I am
still alive.

It is getting so everything is bad for your health. I suspect it has
something to do with the war on cars.

Paul Lamar


PEG  is a deadly poison.  It is  used to euthanize horses.  Small
animals like  your dog find its sweet taste appealing and many have
died after licking spills.  I don't want the stuff around.   There is a
"safe" alternative antifreeze called Sierra on the market.  It is
Proplyene glycol.   At 60 percent concentration with a 15 lb cap,  it
offers boil over protection to 261 degrees according to the label.
Jerry

I am not drinking EG! It is also great to rub on your poison oak affected skin.
Can you drink PG? :) 

Seriously do you have the heat transfer characteristics of Sierra
such as provided by Bill Schertz? At what temp does it boil at 70%?
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.