Yes. I agree with all of this. I am not arguing these points but none
of this is the same kind of show stopper that boiling your engine over
is. I as I said, you don't have to run the engine continuously at 250 F
let alone 300 F to get the margin of safety that a 300 F boiling
temperature provides. You will not get the relatively sudden
catastrophic failure of the engine you will get if the engine boils over
in the air.
Maybe the engine will be damaged if it runs at 250 F to 275 F but at
least you can make it to the nearest airport and land safely.
Perhaps we can find a modern fluid that overcomes some of these
problems. People have run pure 300 F boiling temp propylene glycol with
no obvious disadvantages other than it becomes slush in cold weather.
Thanks to Ken Welter that has tried it in a rotary. Evans has been
selling it for use in race cars for years. If you recall Jeff Spitzer
was dead
set against it use for the reasons you mentioned above.
Do you have similar data for propylene glycol?
Paul Lamar
"Schertz, William W." wrote:
Paul,
Here is a (34page) presentation that was made a few years ago from Evans
Coolant. Probably has more than you want on Propylene Glycol. Also too
large for the list, but a number of cooling curves in it.
It is the pumping power, the need for increased flowrate, and the lack
of knowledge on design of the air-fluid exchanger that makes me hesitant
to use either neat propylene or ethylene glycol in a plane application.
Bill Schertz
KIS Cruiser #4045
Thanks Bill. I'll take a look and see if there is something I can extract and upload.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.