Regarding cars / trucks overheating in the mountains when towing
trailers... It happens (I think) because the vehicle cooling system
is woefully underdesigned if the intention is to pull a lot of power
continuously. Also, I stand by my statement that NO cars run full
rated power, even hauling trailers through the mountains. Full rated
power occurs at or near the "redline" RPM, with foot on the floor!
Not living in the mountains, I don't know for sure, but I doubt that
one is running the car at 5500RPM wide open throttle for more than a
few moments even when trying to climb a steep grade. As a "sanity
check" on the cooling system design, look at the fan and radiator
size of an American V-8 sedan or pick up truck rated at about 300
hp. Now, look at the fan and radiator size of an over the road
tractor trailer. The power rating is pretty similar, and the diesel
engine's heat rejection to the coolant is quite a bit lower than for
the car... but the heavy duty truck's radiator is probably four
times the size of the pick-up truck's radiator.
Jon
Good points Jon. One big difference is the big trucks go up the hill
at
30 MPH where the dynamic pressure to force air through the rad is
1/4 of what it is at 60 MPH. With a big rad you can use a bigger
higher
HP fan. On a five percent grade at 30 mph or 44 FPS forward speed
is 2.2 FPS straight up. At 60,000 pound gross weight that is 132,000
ft pound seconds or 240 HP not counting the considerable tire rolling
drag. That is why they only go 30 MPH.
Paul Lamar
Here you may have a point, but mostly the problem is at the other end of the
rpm band!
Most people will try to keep their rpm LOW to "avoid overheating the
engine"! All wrong!
Today most pickups and SUV's still have a fan that is driven by a clutch and
not an electric motor. To keep the air going through the radiator you got to
give the fan a chance - some rpm to pump the air, also the waterpump needs
to some more rpm to get more gal/min. I don' t mean redlining the engine,
but instead of flooring the pedal at low rpm's, let the engine rev a little,
say in the 75-80% rpm range, just don't ask for ALL the power at this rpm!
Todays engines have a pretty flat torque curve, so it is easy to keep it
rolling at relativly low rpm.
On the other hand (European) Heavy Trucks (40 tons, 520 hp, 14-18 liter
engines) have all electric fans and you can hear them step up the speed when
you start to pull uphill, but still you want to switch down half a gear and
raise the rpm to keep the water running....
One other thing:
To me, this whole cooling discussion makes only sense, if you find an
alternative cooling liquid, that will keep everything together if all else
fails, mainly the pressure in the system. I guess it is no big deal to raise
the pressure on water/mix but if you loose the pressure you loose the engine
because water goes vapor in a hurry!! A far as I can see EG is not a whole
lot better there...
Ken, at what pressure did you run your pure Evans?
In case this is somewhere low, we might want to look for a way to make it
more low temperature compatible instead to try to make the ultimate
race-plane with all its high intensity maintenance.
Thomas J.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.