George Lendich wrote:

George, I think this is something like what Butch had in mind.
He is probably off in God know where doing what ever he does there.

Paul Lamar

Paul,
Yep looks close matey, I hope he hasn't taken off again, he's supposed to
send me the drawings so I can start work on the final Pattern.
George (down under)

I just noticed something else. None of the starters will mesh properly
as this 89.4 mm dimension is too large. The starter mounting faces
must
be 3.05 " or about 77.5 mm from the back of the engine.
Are you there Butch?

Paul Lamar

Ops I may be wrong about that. I think I forgot to add the 1/2 inch
plate
thickness. Could be 90.17 mm from engine to starter mounting surface.
Looks like Butch has it right in this view.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.