Butch,
Would you recommend welding in a plate rather than leaving the end

open.

My thinking is eliminating possible flexing and optimising stress

transfer.

George

******Yes George, by all means, since the weight penalty is minimal

after

adding a couple of Inspection holes....However caution must be taken

upon

welding these plates on:

The preferred way is to cut the Casting, fit and weld the plates PRIOR

to

machining. If this becomes an ordeal to do:

Fitting and welding on the Plates to a machined Bellhousing can be

done,

providing the Bellhousing is properly bolted on a scraped engine rear

housing

that has a good, clean mounting face on it......This is a job for a

"PRO"

guys, somebody like Ed.......I personally wouldn't touch it with a

10ft pole,

even though I'm an above average welder (ARC, MIG, TIG and

Oxy-Acetylene).

BTW Pushers, you can cut an add'l 1" off on the R/H side of the

Bellhousing

if you want to make it narrower and lighter......(See attachment)

Butch

George, I think this is something like what Butch had in mind.
He is probably off in God know where doing what ever he does there.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.