I was in the dealer ship for the 7,000 mile RX8 service
     and I checked
     on
     the cost of the manual TX bell housing suitable for a Don
     Dunbar style
     PSRU. $604 so the junk yards will be about $300 if you can
     get
     them to sell you just the bell housing. I imagine they
     would
     like you to buy the whole TX for more.

     Can you bring your bell housing in for less than $600 US
     George?

     Paul Lamar

Our marine bell housing (may or may not be suitable) sells for
$447.00 (MSRP), for "the list," they would be $360 (about 20% off).
They do not use the standard RX-7 starter (but could possibly be
adapted), and they will not fit a std. trans flywheel -- we make
aluminum flywheels to fit A/T counterweights, the housing matches
the reduced stand-off of our flywheels.

Looks like it could be adapted to Tracy's PSRU.

What does it weigh Jon? What starter do you use?

Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.