George Lendich wrote:

I was in the dealer ship for the 7,000 mile RX8 service and I checked
on
the cost of the manual TX bell housing suitable for a Don Dunbar style
PSRU. $604 so the junk yards will be about $300 if you can get
them to sell you just the bell housing. I imagine they would
like you to buy the whole TX for more.

Can you bring your bell housing in for less than $600 US George?

Paul,

I hope it's a lot cheaper than that !! But any cost will depend on the
machining costs. The foundry costs are not high.

George

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.