Subject: 4Rotor - Part 1 of 4
From: ACRE
Date: 2/14/2004, 9:31 AM


Erik Duley wrote:

Hi Paul

I saw this N/A 4 rotor powered RX7 on the cover of a magazine
(March 2004 - New Zealand Performance Car) here in NZ and had
to buy it. I scanned in the article and here it is - Enjoy :-)

The rest of the parts follow this one.

Regards, Erik


Unfortunately those picts are way too large to publish so I had
to do some severe cropping. This is about the best I can do.
Thanks Erik for sending them. Perhaps if someone is really
interested you can send them direct. It would be a nice Reno
racer engine if it holds up for 15 minutes at full power. Since
the e-shaft is more or less a copy of the Mazda four rotor shaft
I see no reason why not.

Paul Lamar

Eric,

I would be very interested in the whole story! So if you don't
mind, please send me a copy of the works - text, photos, scans,
whatever you have on this one (and others, should you generally be
in the scanning bussiness!!)

Thanks,
Thomas Jakits
rijakits@cwpanama.net

Eric I suggest you use OCR on the text as the original scans were
very hard to read. In that case we can publish the text.

Paul Lamar

Here are a couple of things I noticed about the engine.

BTW see if you can read the small text on the left of this picture.

Paul Lamar

n, buf (or but)
***
n, A
***, in
 drive
, a
old (or did)
*rly
****f
*

avon (I think)
 this
* a
*sted

**rt

Not enough there to mean much even if you could read it.  This was
picked up with ImageMagic with the size doubled twice.

Bob White

- - - - - - -
http://www.bob-white.com
N93BD - Rotary Powered BD-4

Well true Bob but my point was the text I cropped off was too small
to read.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.