Here is a quick and dirty cut and pasted 3D. This is looking heavier
and heavier sand cast in aluminum. I am beginning to think Don
Dunbar
is on the right track.
When you figure the weight and the machining cost of this thing you
are up to a RX8 bell house cost. Here is a picture of the RX8
starter
and manual TX light weight die cast bell housing. The RX8 auto TX
bell
housing is not suitable.
If I were you George I would make yours to fit the RX8 bell housing.
Sorry I did not think of all this while Butch was still here but I
just
got around to making a 3D on his new design.
Paul Lamar
easy to disassemble.
Here are pictures of Don's housings for comparison purposes.
I don't want to discourage you guys but we need to explore all the
possibility
as casting a bell housing and machining it is a lot more expensive
than
casting a gear case and machining it. Most of the later work can be
done on
a lathe and not on an NC mill. There is also a possibly of using some
of
Tracy castings and housings with the stock bell housing.
Paul Lamar
Paul,
I like this direction. We can recess the psru into any bellhousing we
want (incl the 20B/FD auto tranny bellhousing which uses the 9 o'clock
gear reduction starter spanning the end housing and bellhousing). That's
my preference.
Maybe Tracy would be willing to supply kits to do this?
I would appreciate seeing Don's pics again.
[Marc Wiese]
I want to warn you the RX8 manual TX has a different shaped large hole
in the bell housing. Based on the second gen turbo manual TX
the hole should be big enough to clear the ring gear and ring gear
housings.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.