Subject: Carbon fiber bell housing
From: ACRE
Date: 2/17/2004, 6:18 PM


Paul,
        Hello. Composite's biggest cost is the tooling, possibly 10 times
the cost of the finished product. Saying this, if you can use more than 10,
or sell more than that, the cost becomes feasible. There really isn't any
magic to any of it, just knowledge and experience. So, the cost of high
performance carbon stuff is the labour, often we don't even charge out for
the materials. based on your drawings, it looks like a fairly simple shape,
with no bearing race mountings. I take it that the oil is contained in the
front planetary drive section, and has nothing to do with this part. The
mounting points onto the block would need aluminium hard points, and then
they get steel sleeves with integral washers pressed and glued on to the
front of the part. A rough guess right now is the finished part, with mount
hard points, might cost $700. Again, this is a rough guess, considering
layup time and autoclave time. If you had higher quantities in mind, we
could work this down more I'm sure. FWIW, our structural carbon parts
usually weigh 0.4 that of a similar cast part, and have
tensile strengths of
around 130 ksi. Thanks,
                                        David Algie


Did you happen to notice the propeller that he had on his web site?

Brian Trubee

Yes but judging by some of the statements he makes on his web site I
would be a bit wary of his engineering abilities. If he made a bell
housing for
us it would be to Butch's drawings.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.