Subject: PRIVATE Carbon fiber bell housing]
From: ACRE
Date: 2/17/2004, 5:36 PM

PRIVATE

I think you could sell 50 a year depending on the price.
A new RX8 die cast bell housing is $600

Paul Lamar

David Algie wrote:

Paul,
        Hello. Composite's biggest cost is the tooling, possibly 10 times
the cost of the finished product. Saying this, if you can use more than 10,
or sell more than that, the cost becomes feasible. There really isn't any
magic to any of it, just knowledge and experience. So, the cost of high
performance carbon stuff is the labour, often we don't even charge out for
the materials. based on your drawings, it looks like a fairly simple shape,
with no bearing race mountings. I take it that the oil is contained in the
front planetary drive section, and has nothing to do with this part. The
mounting points onto the block would need aluminium hard points, and then
they get steel sleeves with integral washers pressed and glued on to the
front of the part. A rough guess right now is the finished part, with mount
hard points, might cost $700. Again, this is a rough guess, considering
layup time and autoclave time. If you had higher quantities in mind, we
could work this down more I'm sure. FWIW, our structural carbon parts
usually weigh 0.4 that of a similar cast part, and have tensile strengths of
around 130 ksi. Thanks,
                                        David Algie
                                        Algie Composite Aircraft
                               http://members.iquest.net/~aca/


David,

Can you make some of these out of carbon fiber?
What would be the approximate cost?

Paul Lamar