Mark Steitle wrote:
Paul,
The recent article on the custom built 4-rotor talks about an
auxilary oil
pump fitted to the metering pump pad. I was curious if it would
be
beneficial to use the metering pump pad to mount a separate psru
pump,
along with a separate oil reservoir. This would allow the use of
gear lube
vs. engine oil in the psru. While this would add weight and
complexity, it
seems that if it would extend the life of the psru considerably it
might be
worth it. I would appreciate your thoughts on this.
Mark S.
I think that is a good idea. I am a bit skeptical if the drive has
enough
torque capacity to drive a high pressure engine oil pump however.
The gears are kind of small. Here is a small oil pump I made out
of pinion stock.
Paul Lamar
What about the aux oil pump offered by someone on this list, (don't
remember who), used to pump 2 stroke oil. Would this have enough
umph to push gear lube? Tom Webber
That is Richard Sohn. It is not a pump. It is just a way of getting
two cycle oil into the stock apex seal oil metering pump.
A redrive oil pump should reduce the PSRU temp.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.