Subject: Aux. Oil Pump for PSRU
From: ACRE
Date: 2/19/2004, 9:56 AM

Mark Steitle wrote:

Paul,
The recent article on the custom built 4-rotor talks about an auxilary oil
pump fitted to the metering pump pad.  I was curious if it would be
beneficial to use the metering pump pad to mount a separate psru pump,
along with a separate oil reservoir.  This would allow the use of gear lube
vs. engine oil in the psru.  While this would add weight and complexity, it
seems that if it would extend the life of the psru considerably it might be
worth it.  I would appreciate your thoughts on this.

Mark S.


I think that is a good idea. I am a bit skeptical if the drive has
enough
torque capacity to drive a high pressure engine oil pump however.
The gears are kind of small. Here is a small oil pump I made out
of pinion stock.

Paul Lamar


Not sure why you would want to use gear lube. That stuff is thick, and uses more
power to turn the gears.
Royce

Best is probably synthetic auto transmission fluid with its own little
oil cooler. I think this is a great idea. Especially for the three
rotors
that put more stress on the PSRU.

Paul Lamar


Those planet gearsets run in allison automatics in big trucks and tractors in plain
jane auto trans fluid and never have a problem with the gears. GM also uses it in some
of their high performance manual transmissions as well. Seems that would be the lube
to stay with, although synthetics would also be just fine. The auto trans fluids are
easier to pump than a gear lube.
Royce.


Last week temp inside my shop was about -10 C. and you
could not pour 80/90 gear lube.  Think of liquid honey.
Now
store it in the freezer and try and pour it. Pumping it
on
those cool morning start ups will suck some HP. for
sure.
Bryan in Princeton  B.C.


Try RedLine 80/90wt. Freeze it and it barely thickens. The
car guys I built for said it was good for .5 -2 hp on the chassis
dyno in the gearbox and rearend.
Bill Jepson


Just like the old Mini Coopers, sharing gear box oil with the engine can lead
to misery.

A friend tried to drive an engine oil pump with the distributor drive, and
the distributor gear dissolved before the session was over. (Steel gear on a
steel gear) This when we all thought that 75 PSI was a bunch of pressure.

The gear box should have it's own oil supply and it should be cooled. The
lube should be 100% synthetic and there should be a spray nozzle to direct cooled
oil at the junction with the highest wear.

 In my opinion.

A problem in the gear box should not be allowed to become an engine problem.
The pump can be very small and should be a stand alone run from the pulley
end. If the oil output is relatively unrestricted, there will be little power
absorbed.

Lynn E. Hanover


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.