Subject: Aux. Oil Pump for PSRU
From: ACRE
Date: 2/20/2004, 10:33 AM


Just like the old Mini Coopers, sharing gear box oil with the engine can lead
to misery.

A friend tried to drive an engine oil pump with the distributor drive, and
the distributor gear dissolved before the session was over. (Steel gear on a
steel gear) This when we all thought that 75 PSI was a bunch of pressure.

The gear box should have it's own oil supply and it should be cooled. The
lube should be 100% synthetic and there should be a spray nozzle to direct
cooled
oil at the junction with the highest wear.

 In my opinion.

A problem in the gear box should not be allowed to become an engine problem.
The pump can be very small and should be a stand alone run from the pulley
end. If the oil output is relatively unrestricted, there will be little power
absorbed.

Lynn E. Hanover

Since we are not talking big GPM need, do you think ordinary electric fuel
pump will do the job? I have a nice 12V gear pump, but it's pumping 3 GPM
and will work at 30-40 psi all day long. For small amounts and the thin auto
transmission fluid, Tracy's fuel pump may do the job?
Bulent

If you are using Tracy's psru you will need at least 45 psi and maybe
more to adequately supply the plain bearings. At this point in time I
know
not how many gallons of oil per minute his bearing require but there
is
probably something that can be looked up in Marks Mechanical
Engineering
Hand Book.

Paul Lamar

"Lemings, Bob" wrote:

Pardon my ignorance, but all motor vehicles I have encountered with rear wheel drive have splash lubricated, enclosed oiling systems.  Front wheel drive units are a mix-- some automatic transaxles are lubricated with automatic transmission fluid, others have their own supply of gear lube, splash type.  No manual transmissions or differentials I have ever encountered have been equipped with oil pumps.  (Mobil 1 Synthetic gear lube works great in the manuals, by the way).

Having said all that, are the demands on a PSRU so much greater than those of a heavy vehicle that splash lubrication is inadequate?  I am about to begin construction of a plane and plan to use a 13B engine with Tracy Crook's redrive and had also considered using a separate lubricating system for the PSRU, and need to learn as much as possible before I make hard decisions.

Bob Lemings

Some race cars use aux pumps and oil coolers. A lot depends on the
continuous
HP the gear box is transmitting. Most cars transmit only about 45 HP
continuously. Here is how it works. Most gear boxes are in the range
of 99% to 97% efficient. At 200 HP transmitted that is 2 HP into the
gear
box for every one percent reduction in efficiency. Lets say it is
indeed
99% efficient however unlikely. Converting HP to watts at 746 watts
per HP
that means the gear box must dissipate 1500 watts or about the amount
an
electric room heater puts out. In the normal set up the oil is shared
with
the engine so this extra heat must be dissipated by the engine oil
cooler.

It is kind of minor addition however because the engine is dissipating
about
133 HP to the coolant one third of that going to the oil in a rotary.

Here is the rough heat balance for all ICE's that are roughly all
about 30%
efficient over all.

.3 X = 200....  X = 200/.3 = 666 HP total in a gallon of gas.

200 HP out
133 HP to the coolant (40 HP of that to the oil)
333 HP to the exhaust.

BTW This is why turbo compounds are so attractive.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.