I think it might be practical if your PSRU did not require 3 gallons
per minute
at 45 psi or more as Tracy's does.
Paul Lamar
I agree Paul, but it brings up the point that (it seems) the biggest problem
of oiling is not the gear-set but the bearings.
I personally feel running the gearset in an oil bath is sufficient - but
after reading up on the bearings, pressure feed to the bearings is optimum
and plain bearings need this more so than other bearings.
So I will trial, splash feed, then pressure feed to the bearings (taper
roller), then pressure feed to the bearings and gear-set.
Only time will tell.
BTW a pump can be run of a cam on the shaft.
George (down under)
Plain bearing need pressure absolutely.
BTW with the needle bearings in a Ross a small electric pump
circulating
the oil through a cooler ought to work fine. It is just Tracy's PSRU
that
uses plain bearings. If you can turn off the pump on the occurrence
of the alternator failure then the psru should still work fine until
you
can find a place to land.
Also since we don't need the crank angle sensor anymore a high
pressure
mechanical fuel pump could be driven by that shaft. This would greatly
extend the range in the case of an alternator failure.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.