Tracy is already running Mobil 1 in his engine. The problem is the oil
in the engine runs 220 degree F. The gear box does not need to run at
that temp. The life of the gears is sure to be higher if the box is kept
cooler while using oil that is best suited to gears. That means
extreme pressure gear lube synthetic 15W 50 or some such. Also as some
one
pointed out a problem in the engine does not need to destroy the gear
box and vice versa.
Paul Lamar
You have touched upon a subject that I have wondered about for years.
Specifically, with a multi-viscosity oil such as 10w40, my understanding
is
that the oil has the viscosity of straight 10w at low temperatures, and
the
viscosity of straight 40w at higher temperatures. My question is whether
this 10w40 oil at higher temperatures has the viscosity of a straight 40w
at
that same higher temperature, or of straight 40w at say room temperature.
The point being that straight 40w would be thinner at higher temperatures.
Any comments, or am I all washed up on the subject?
Harrison Young
API viscosity grading is performed at two temperatures: 40c and 100c.
Straight 40 oil has to have a viscosity of between 12.5 and 16.3 centistokes
(cSt) at 100c. These oils have to meet a high temperature/high shear
requirement at 150c. There are no 'winter' pumping or cranking requirements.
10w oil has to meet a minimum viscosity requirement at 100c of 4.1 cSt, but
has to exceed the cold crank requirement at -25c and a pumping requirement
at -30c. Multi-grade oil has to meet both hot and cold requirements.
If a base oil doesn't get close to meeting the requirements for a particular
oil - which is much harder to meet as the 'winter' and 'summer' performance
requirements spread (a 10w30 is easier to blend than a 0w50) - the chemists
pull out some pour-point suppressants to enhance the cold performance, and
toss in some viscosity index improvers to 'thicken' the oil at higher
temperatures. The down side of the additive mix is they are usually the
first components in the oil to break down. I've seen some 10w40 petroleum
turn in to a 10w20 after only 4000 miles. The high temperature/high shear
testing done at 150c gives an indication of how well the VI polymers resist
being severed. I have no idea what the upper temperature limit of a VI
additive is. I would expect that they could thicken the oil up to a certain
temperature, beyond which they are pretty static...then the heat continues
to increase and everything starts to break down.
Andy Hecker
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.