Subject: PSRU and lubrication circulating pump
From: ACRE
Date: 2/20/2004, 12:39 PM


Paul.
I have had problems with my internet ISP only just seen above.
I had thought of keeping the PSRU oil separate from the engine but being
fairly new to the list, I  did not ask the question as I assumed it had been
discussed in the past.
The subject was discussed on another list last year, someone said that no
car had
a common oil supply for engine and gearbox, they were all very surprised
when
I told them about the Mini Coopers and other transverse engine car engines
that
were produced in the UK by BMC.
I have had Mini coopers, the sump plug had a magnet fitted in it to collect
any
 metal particles, when you drained the oil the magnet looked like a xmas
tree with all the bit of metal attracted to the magnet.
I very much hope that this would not happen with the PSRU,but for this
reason
I would prefer to have a separate oil supply.
As the oil in the rotary engine is used for cooling the engine and runs at a
fairly
high temperature is it not heating the PSRU rather than cooling.
I do not know how hot the PSRU gets but did think of a small oil cooler
built round
the front of  the PSRU to take advantage of the cool air from the prop.
I don't think engine oil is the best choice for the gears, what oil is used
in the ford
gearbox ?
All the cars I have had apart from the Mini Coopers use a gear oil which is
a very
different engine oil.
For a separate oil supply I was thinking of using a power steering oil pump,
which
might be driven off the output shaft of the PSRU, I have one here from a
Subaru.
I think it is very important to consider the lubrication of the gears and
bearings, from
some of the photos I have seen doing my research on the net it looks like
the oil supply
was an afterthought.
Having just got a set of gears I have see that they have oil ways and holes
for the oil
supply to the gears, I think that just squirting some oil into the gear
housing somewhere
and hoping it will get to all the parts that need lubrication is not the
best way.
In the Ford gearbox are the gears run submerged in the gearbox oil? if you
have looked at
the complete ford box where is the oil level relative to the shaft
assemblies, I cannot
find this out as the truck is not sold in the UK, I would appreciate some
feed back on this.
Geoff
Cheshire
England

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.