That looks like a great instillation with a couple of exceptions. I
have often
though that a turbo 3-rotor is the perfect engine for the fast glass
planes.
My impression from those picture is:
This stuff is straight from Adkins. There is no doubt that he was
involved.
The coils, fuel rails and regulator, accessory belt and short intake
design
have Dave Adkins written all over them.
Good points: that mount looks good. It is out of the way of
everything like
intakes, exhaust and turbo; yet it has the benifits of a conical
mount. It
does look like the front conical holds have only 2 supproting tubes.
The workmanship and appearance of the
intake and oil pan appears great. The PSRU is either Powersport or
Marcote and looks
great except for the rust on the prop flange.
Things to do different:
1) there is a rubber hose touching (or very near) the exhaust pipe.
Obviously
not good.
2) C'mon! any serious turbo charger need an intercooler!!! 'nuf said.
3) My eyeball caliper says that it wont cool. Not 350 h.p. anyway.
4) The routing of the belt over the water pump only leave about 30
deg of bite,
I would be very worried about slipage.
Dave Leonard
Turbo RV-6 project getting close... slowly
You sound conflicted Dave :)
Paul Lamar
Theodore James wrote:
I think a few good points have been hit upon here. An inter-cooler is
probably needed. But most important, it appears to me as though the oil
coolers reside behind the water coolers, and I don't see how that could
work. It also looks to me, (and maybe I am missing something) like the
hoses and fittings will never carry enough water to cool HP being
produced.
(It would have been a good idea to continue to protect the steel parts
from the elements.)
TJ
Tedd James
612-676-0118 Office
612-840-1717 Cellular
612-617-7743 Fax
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.