Subject: Air Worthiness Certificates Was: Re: turbo 20b in Lancair
From: ACRE
Date: 2/21/2004, 9:44 AM


One further point on this.  The log book entry return to service
only applies to later Operating Limitations.  For example, my
airplane was last issued Operating Limitations in 1989.  Item 3
says "Any major change to this aircraft, as defined by FAR 21.93
invalidates the Special Airworthiness Certificate issued for
this aircraft."  If I had been a little smarter, I would have
had the previous owner update to the newer Operating Limitations
before I purchased it.  Then I could have used the log book
entry and prescribed fly off time.  As it is, I will have to
start from the beginning to get a new Special Airworthiness
Certificate. When it is issued, it will have the newer Operating
Limitations.

Ah yes.  I had forgotten about the change in the standard operating
limitations boilerplate that happened a few years ago. Thanks for
pointing that wrinkle out.

Bob, check with the local FSDO office. IIRC, there's a procedure for
getting the operating limitations updated to the new boilerplate
without alot of fuss.

Russell Kent

Russel,

I've checked.  It's easy to do if you haven't already started a major
mod, like pulling the lycoming engine out and putting a rotary on it.
Once the mod is started, the airworthiness certificate is cancelled.

I suppose one could have just not mentioned it, but it dosen't seem the
best policy. :)

The only downside is that I will be "required" to spend more hours
flying in the local area.  I was planning on a complete test sequence
even without the requirements.

Bob White

- - - - - - -
http://www.bob-white.com
N93BD - Rotary Powered BD-4


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.