Bob Fritz wrote:
Hi Paul,
I'm putting a 13B in an RV6 and I see that you've an intake manifold
casting. Where/how can get some more info?
Thanks
Bob Fritz
I have some of those left. $180 plus $15 shipping and handling.
The lower part in these pictures is what it looks like. The plate
and tubes are not included.
Send check to me at:
830 East Santa Maria St.
Suite 303
Santa Paula CA
93060
Paul Lamar
Bob Fritz wrote:
Paul,
Well, it looks like a good start...but where do the injectors go? I saw
a photo of four separate injector ports that I assumed were to be placed
in the flow path between each tube and the manifold
Bob
We have injectors holders/bell mouths casting for $45 each.
You weld them together to form one wall of the plenum.
This gives a lot of flexibility as far as pipe length for tuning is
concerned.
1/4 inch cast iron plumbing pipe is just the right size for
the jig stubs.
