My 13b engine is ready to run....I ordered a VAM muffler, but since
it has
not yet happened, I was wondering if I could get away with using the
stock
cast iron manifold with a straight pipe attached to it, which would
exit
through the bottom of the cowling. I should mention that this is on a
pusher. George Graham told me that he was using a straight, (or
slightly
bent) pipe, and possibly Perry Mick is or was using the stock cast
iron
manifold?  My thinking is that although it is heavy, it might

possibly

absorb a lot of the initial heat as it is exiting the exhaust ports,
acting
like a heat collector, and I might not need expensive inconel or 321
stainless after the exhaust goes through the stock manifold first?
Would
the cast iron manifold absorb much of the heat and possibly muffle
some of
the noise as it is bounced around inside of the stock manifold?  I'm
probably grasping at straws, but with all the knowledge and
experience in
this group, I figure it wouldn't hurt to ask.  Thanks to all for your
opinions and advice.  Paul Conner, 13b powered SQ2000

The stock exhaust manifold is very good at reducing noise, if you have
room you may want to consider a racing beat header...
Hans Conser

Is the Racing Beat headeer also good at reducing noise?   Thanks.  Paul
Conner

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.