Subject: Exhaust manifold and pipe
From: ACRE
Date: 2/26/2004, 10:12 AM


Just wanted to thank everyone for their valuable input regarding the use
of
the stock cast iron exhaust manifold and a short pipe extension for my
SQ2000 canard pusher.  I installed it yesterday.  Today I finished
wiring up
my MicroTech ECU.  I just need to install the fuel return line from the
fuel
pressure regulator to the sump tank, and she's ready to make some noise.
I
ordered the stainless steel wrapped hose. As soon as that arrives, I
should
find out how loud this thing is. Here is a picture of the exhaust
installation, and yes, I will install the heat shields.  Thanks again to
all
who responded and contributed to this exhaust installation. Paul Conner


Paul C., Where did you puchase those welded on AN fittings for your cooling
system? Thanks. Bill Hyde

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.