Subject: Exhaust manifold and pipe
From: ACRE
Date: 2/26/2004, 7:27 PM


Just wanted to thank everyone for their valuable input regarding the use
of
the stock cast iron exhaust manifold and a short pipe extension for my
SQ2000 canard pusher.  I installed it yesterday.  Today I finished
wiring up
my MicroTech ECU.  I just need to install the fuel return line from the
fuel
pressure regulator to the sump tank, and she's ready to make some noise.
I
ordered the stainless steel wrapped hose. As soon as that arrives, I
should
find out how loud this thing is. Here is a picture of the exhaust
installation, and yes, I will install the heat shields.  Thanks again to
all
who responded and contributed to this exhaust installation. Paul Conner


Paul Connor,

First of all nice job - I would be particularly interested in how the
MicroTech ECU works for you as they are made in Australia and have a good
name and are relatively cheap compared to imports, however I am completely
ignorant on ECU's.
I do wonder how you lean MicroTech in flight and would love to discuss the
pro and cons off-site so as not to jam up the newsletter - could you contact
me at lendich@hypermax.net.au.

I am also very interested on how well the 2 into 4  intake manifold works as
I have been told the 4 into 4 are only needed at the much higher RPM's.
I will go the two 2 into 4 if they work well enough.

George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.