Paul C., Where did you puchase those welded on AN fittings for your
cooling
system? Thanks. Bill Hyde
Hi, Bill....I found a couple of sites/sources for those fittings. Try
www.bakerprecision.com/adapt7.htm also
www.poske.com/parts/Earls/alfit3.htm Hope this helps. Paul Conner
Baker is REAL EXPENSIVE. Earl's or Summit is best as I have been doing
a lot of buying AN fittings lately.
Paul Lamar
Jerry Bass wrote:
I found fittings at Jeg's Catalog or on line at www.Jegs.com AN fittings about 1/3 the cost.
Jerry Bass
540-932 3125
Cell 241-2675
Good work Jerry. Those suckers can get expensive.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.