First of all nice job - I would be particularly interested in how
the
MicroTech ECU works for you as they are made in Australia and have a
good
name and are relatively cheap compared to imports, however I am
completely
ignorant on ECU's.
I do wonder how you lean MicroTech in flight and would love to
discuss
the
pro and cons off-site so as not to jam up the newsletter - could you
contact
me at lendich@hypermax.net.au.
I am also very interested on how well the 2 into 4 intake manifold
works as
I have been told the 4 into 4 are only needed at the much higher
RPM's.
I will go the two 2 into 4 if they work well enough.
George (down under)
Hi George
Use the up arrow to get to 'Mix Trim' then the + or- to adjust mixture %
up
or down. The Data page shows mix ratio if you have an EGO sensor. It
is
also possible to use the Cruise function.
Ian (also down under.)
Hi, Ian....thank you for answering that question regarding leaning the
MicroTech. I scanned that portion of the manual, but since I was not ready
to start the engine, I hadn't really looked at it very closely. Hoping to
start the engine in a few days. The MicroTech has a basic program for the
rotary that I assume should be good enough for initial start-up. I may
pester you in the near future with questions concerning this little black
box, if I may. Thanks again. Paul Conner
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.