Mark Supinski wrote:
Hi Paul-
We recently acquired a Mazda Turbo II engine to rebuild for use in our
Mustang II kit plane.
The engine we have was imported directly from Japan -- not as part of
car, but as a used engine pulled from a vehicle
in Japan. We are unsure of what year it truly is -- ie, is it really a
turbo-II (since the date ranges for US
turbo-IIs might be different than the ranges in Japan). Can you
identify it from the pictures? Is there someplace on
the engine we can find serial numbers? All we can find is 13B on the
rotor housings.
FYI, we'll be fully rebuilding based on the Bruce Turrentine video we
got a few weeks back.
Regards,
Mark Supinski & Mark Precious
It is definitely a 2nd gen Turbo II but I cannot say whether it is an 88
or a 90
with the turbo heat shield on there. There is a critical difference
as the 87's 88's cracked with regularity while the 89's 90's 91's were
more robust.
BIG difference in used prices.
If you take the heat shield off and take a close up picture of the turbo
I can tell you which it is.
Paul Lamar
"Brian D. Cain" wrote:
It's a series 4 (1987 and 1988 year model). It has 10.5lb, 8.5:1
compression ratio rotors and slightly smaller
intake port runners over the Series 5 (1989 to 1991) models. It also has a
27lb flywheel and the same Hitachi
HT18 turbo the latter model uses except the turbine housing is slightly
smaller with some 'twin scroll'
contraption.
B
__________________
Brian D. Cain -/- Grand Prairie, TX -/- bdc196@killspam.comcast.net
bdc@killspam.teamfc3s.org
BDC Motorsports - Performance Rx-7 13B Rebuilds, EFI tuning, etc.
MSN bdc196@killspam.hotmail.com, Yahoo! bdc196, AOL Symajhi, ICQ# 1733105
http://bdc.cyberosity.com -/- http://groups.yahoo.com/group/HaltechSupport
Unfortunately the turbo that cracks.
The good news is the 89-90 turbo and manifold will bolt right on.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.