Just wanted to thank everyone who contributed to getting this 13b

running.

I

have the stock cast iron exhaust manifold with a short pipe to clear the
cowling, and I'm pleased that it was not as loud as I had expected.  I

guess

the cast iron absorbs some  of the engine pulses.  It certaintly absorbs

the

heat. For those that noticed the missing heat shields....not to worry,

they

will be installed.  I have only ran it for a few minutes at a time, so I

can

set up my MicroTech ECU and also to purge any air from the coolant

system,

but it sure runs smooth.  Glad I went with a rotary.  Thanks again for
everyone who answered all my questions....even the dumb questions.
sincerely,  Paul Conner

-Joe Hull wrote:

Hey Paul - Congratulations!!  Are you building a Cozy?
Where'd you get the 1 1/2" adapters for flex hose to your radiator and

water

pump??

Thanx,
Joe Hull (joeh@PilgrimTech.com)
Cozy MkIV #991 (working on Engine & Cowling)
http://www.maddyhome.com/canardpages/pages/JoeHull/index.html

CBarber wrote:

I believe Paul Conner is building an SQ2000 (Speed Queen) not a Cozy.

Christopher Barber

Barber & Pi, LLP
Attorneys and Counselors at Law
11930 S Sam Houston Pkwy E
Suite 103
Houston, Texas 77089-4755
281-464-LAWS (5297)

"Serving the needs of Senior Texans"

CBarber@TexasAttorney.net
www.TexasAttorney.net <http://www.TexasAttorney.net>

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.