Monty Roberts wrote:
Group,
This plane has been ARF (Almost Ready to Fly) for some time now. They
were supposed to fly it on battery power first. That was supposed to be over
a year ago. Perhaps they are having problems reaching the much desired 1G in
lift? In my work I have been involved with the equipment for producing PEM
fuel cells. The technology is very interesting. As Paul has mentioned
however the Hydrogen technology is not energy efficient. The power required
to make H2 is higher than the energy out. The only practical way is if you
can store the H2 and produce it over time using electrolysis. Not useful for
fueling the general public.
Bill Jepson
Bill,
I'm with you on the fueling the general public (currently). I used to be
with you on the total non-usability of hydrogen. Then I started looking at
the fact that electric motors are in the 90% efficiency range. Fuel cells
are as well. So you only have to carry around 20% of the fuel load. Add to
this the fact that you are not altitude limited (if you pressurize the air
that goes to the fuel cell). And the inherent simplicity and you start to
see the possibilities. There are limitations and currently the technology is
just not there.
Making hydrogen is energy intensive. So is harvesting crude oil,
transporting it etc. It also matters where your energy comes from. If it is
from distributed wind, solar, and nuclear, who cares if it takes a little
more. There may be some merit to the hydrogen thing, but currently the
storage technology is lacking.
The reduced heat and noise signatures along with high altitude capability
should get the government involved in the development for RPV's. Hopefully
there will be some trickle down.
Monty
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.