Subject: MecanAir redrive on an Allison turbine
From: ACRE
Date: 3/14/2004, 3:47 PM

Francois Badoux wrote:

Hi,



One of you guys (sorry, lost the email and the name) asked me if it was possible to fit our planetary redrive on an Allison turbine (was it a 250-C18 you
mentioned?).  The answer is:  I don't know for sure, never tried.  But I did my homework this weekend and come with the following hypothesis:



Shaft RPM on the 250-C18 is 6000 RPM, with our redrive present ratio of 2.8231:1, it would yield 2125 prop RPM... quite good in cruise, a bit on the low side
on t/o unless you can compensate with a large diameter prop or with plenty of surplus power.  The 250-C18 maximum power output seems to be 317 Bhp, no sweat
for our redrive.  The 250-C20 is 420 Bhp... well, it would definitely have to be tested before flying!



As you are all aware, one of the key design criteria for a redrive is the characteristics of the power pulses generated by the engine.  Tough on the gears in
piston engines, even tougher in diesels, but MUCH better in rotaries, torsional vibration is nil on turbines.  So I don't think we have a problem there... we
could maybe even remove the vibration damper in our redrive.



As I said, it hasn't been tested... and I am no turbine engine specialist... but I guess it would work just fine.  You want one?  J



Regards,  Francois Badoux

You may have to forward this one to Francois as well until he gets his ISP sorted out.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.