Subject: MecanAir redrive on an Allison turbine
From: ACRE
Date: 3/15/2004, 2:18 PM


Francois Badoux wrote:

Hi,



One of you guys (sorry, lost the email and the name) asked me if it was
possible to fit our planetary redrive on an Allison turbine (was it a
250-C18 you
mentioned?).  The answer is:  I don't know for sure, never tried.  But
I did my homework this weekend and come with the following hypothesis:



Shaft RPM on the 250-C18 is 6000 RPM, with our redrive present ratio of
2.8231:1, it would yield 2125 prop RPM... quite good in cruise, a bit on
the low side
on t/o unless you can compensate with a large diameter prop or with
plenty of surplus power.  The 250-C18 maximum power output seems to be
317 Bhp, no sweat
for our redrive.  The 250-C20 is 420 Bhp... well, it would definitely
have to be tested before flying!



As you are all aware, one of the key design criteria for a redrive is
the characteristics of the power pulses generated by the engine.  Tough
on the gears in
piston engines, even tougher in diesels, but MUCH better in rotaries,
torsional vibration is nil on turbines.  So I don't think we have a
problem there... we
could maybe even remove the vibration damper in our redrive.



As I said, it hasn't been tested... and I am no turbine engine
specialist... but I guess it would work just fine.  You want one?  J



Regards,  Francois Badoux


You may have to forward this one to Francois as well until he gets his ISP
sorted out.

Paul Lamar


Francois - that was me, thank you for your reply.  In addition to my
interest in Rotary engines I'm also into gas turbines and in particular the
use of Allison 250 B17 turboprops on experimental aircraft.  I'm impressed
with your homework results.  The prop reduction drive of the RR Allison
factory model takes the 6000 shaft rpm at 2.96.1 to produce a propeller rpm
2025 - so yours is right in there.  317 shp is the size engine I'm using so
that is also in line with your specs. All that remains is the physical size
and the flange mounting.  What is the diameter of your flange and the
length?  Do you have a drawing or photo of your redrive?  Thank you.

Doug Ritter
NASA-TV
On-Air Operations
NASA Headquarters, Code PM3
300 E St, SW
Washington, DC 20546-0001
202-358-0025



 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.