Subject: Water plumbing tubing bends
From: ACRE
Date: 3/16/2004, 9:54 AM


How about RB Wagner? They've got aluminum and SS bends. That's where I got the aluminum bends for my manifold.

http://rbwagner.com


Brian Trubee

Its overkill for water plumbing. .140 wall.
It is also pipe and not tube. Pipe does not come in the right size
for water plumbing. What you need for water plumbing is 1.5 inch OD tube.
This is because of all the standardized rubber hose that is available for 
engine water plumbing. Also the inlet to the Mazda water pump is 1.5 inch OD.

We used pipe on the intake manifold because it is lower cost than tube
and is available in a smaller center line radius bends

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.