X-RCPT-TO: <jerrymarge@mail1.myexcel.com>
Status: R

Well, now that I have my 13b running smoothly, I need to address the
installation of an EGT probe.   I have the Microtech ECU, and an AV-10
engine monitor.  It is my desire to connect the EGT and CHT probes to

the

AV-10 engine monitor. I'm assuming that I can just purchase and install

the

spark plug ring type sensors for the CHT.

    As far as the EGT, I have the original cast iron manifold, with the
oxygen sensor. (My Microtech ECU likes that).  For those of you that are
using the stock cast iron manifold, where did you install your probe for
EGT?   Attached is an older picture of my exhaust system.  Thanks for

any

and all suggestions.  It sure is fun making hmmmmmmm noises.  I am

pleased

that it is not as loud as I thought it might have been.  Thanks again to
all.   Paul Conner

Paul,
I had a look at the Microtec web site and was wondering which model you
chose. I sent off a request for information and got no response at all.
George

Jerry Bass wrote:

I like Tracy's engine control and monitor best.  My exhaust temp probes are about 6" from the block on Race Beat steel flange and two inch pipes.

Jerry Bass
540-932 3125
Cell 241-2675

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.