Well, now that I have my 13b running smoothly, I need to address

the

installation of an EGT probe.   I have the Microtech ECU, and an

AV-10

engine monitor.  It is my desire to connect the EGT and CHT

probes to

the

AV-10 engine monitor. I'm assuming that I can just purchase and

install

the

spark plug ring type sensors for the CHT.

    As far as the EGT, I have the original cast iron manifold,

with the

oxygen sensor. (My Microtech ECU likes that).  For those of you

that are

using the stock cast iron manifold, where did you install your

probe for

EGT?   Attached is an older picture of my exhaust system.  Thanks

for

any

and all suggestions.  It sure is fun making hmmmmmmm noises.  I

am

pleased

that it is not as loud as I thought it might have been.  Thanks

again to

all.   Paul Conner

Paul,
I had a look at the Microtec web site and was wondering which model

you

chose. I sent off a request for information and got no response at

all.

George

Jerry Bass wrote:

I like Tracy's engine control and monitor best.  My exhaust temp probes

are about 6" from the block on Race Beat steel flange and two inch pipes.

Jerry Bass
540-932 3125
Cell 241-2675

Hi, Jerry....thanks for the response.  Just curious....what advantages have
you found in Tracy's over the MicroTech that helped you determine that you
liked Tracy's best?  Unfortunately, I am not familiar with Tracy's to
compare the two. Thanks.    Paul Conner

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.