Mark Supinski wrote:
Hi Paul-
We recently acquired a Mazda Turbo II engine to rebuild for use in
our
Mustang II kit plane.
The engine we have was imported directly from Japan -- not as part
of
car, but as a used engine pulled from a vehicle
in Japan. We are unsure of what year it truly is -- ie, is it
really a
turbo-II (since the date ranges for US
turbo-IIs might be different than the ranges in Japan). Can you
identify it from the pictures? Is there someplace on
the engine we can find serial numbers? All we can find is 13B on
the
rotor housings.
FYI, we'll be fully rebuilding based on the Bruce Turrentine video
we
got a few weeks back.
Regards,
Mark Supinski & Mark Precious
It is definitely a 2nd gen Turbo II but I cannot say whether it is an
88
or a 90
with the turbo heat shield on there. There is a critical difference
as the 87's 88's cracked with regularity while the 89's 90's 91's were
more robust.
BIG difference in used prices.
If you take the heat shield off and take a close up picture of the
turbo
I can tell you which it is.
Paul Lamar
"Brian D. Cain" wrote:
It's a series 4 (1987 and 1988 year model). It has 10.5lb, 8.5:1
compression ratio rotors and slightly smaller
intake port runners over the Series 5 (1989 to 1991) models. It also
has a
27lb flywheel and the same Hitachi
HT18 turbo the latter model uses except the turbine housing is slightly
smaller with some 'twin scroll'
contraption.
B
__________________
Brian D. Cain -/- Grand Prairie, TX -/- bdc196@killspam.comcast.net
bdc@killspam.teamfc3s.org
BDC Motorsports - Performance Rx-7 13B Rebuilds, EFI tuning, etc.
MSN bdc196@killspam.hotmail.com, Yahoo! bdc196, AOL Symajhi, ICQ#
1733105
Unfortunately the turbo that cracks.
The good news is the 89-90 turbo and manifold will bolt right on.
Paul Lamar
We have removed the heat shield and cover to the turbo on our 13b. Based on
the photos which had been posted by someone earlier, I now conclude this is
a 89 -91 turbo -- it exactly matches the photo labelled as such.
"Phew, thank goodness", right??
(Please find attached a 675K image of the turbo unit for good zoom in
purposes.)
My only remaining concern in opening up the cover is what
appears to be a bunch of slag metal that is clearly visible in the center of
the unit. It can't be, but the closest thing it looks like to me is a
practice weld by a beginner welder on his very first practice piece of
metal. Could this hide a post operation hairline fracture or is this just
the internal unfinished work by the manufacturer..... Zoom in and let me
know what you think.
Mark & Mark
That looks just like casting imperfections in the sand mold. They usually don't crack
there. You did luck out. It is the right year.
Congratulations. You got a good one. BTW the turbine looks OK.
Wiggle the shaft and see if it turns smoothly.
Paul Lamar
Mark and Mark,
Do you have your engine mount for the Mustang yet? If so, can you tell me who did it for you? Which PSRU are you planning to use?
Bob Lemings
Bob, Don Dunbar is quite far along with his Mustang. Here are some pictures.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.