Subject: Can you ID this 13B?
From: ACRE
Date: 3/26/2004, 4:22 PM


Paul Lamar

Just for the record, if I were doing it over, I would go with the
Shertz
beam also.  The motor mount plate is a beautiful piece of work, but
besides the cost it causes more interference problems than the Shertz
beam.  At one point I had decided to simplify my life by using the
stock exhaust manifold, and purchased one on ebay.  I couldn't use it
because it runs into the MM plate.

I would also like to separate the gear reduction installation job
from
the engine mount.

Bob White

Bob and Paul,  the cast bell housing is the item we are missing.   Is
it going to happen?   I have not heard anything about it for some
time.     Jerry

George?

Paul,
Yes I'm working away on the pattern from the final drawings of Butches. I
know it's been a little while but we have to get it right.
George

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.