Subject: Can you ID this 13B?
From: ACRE
Date: 3/26/2004, 11:53 AM


Here is a better lower cost way of doing it that gives more clearance for a turbo charger
or a muffler. It is similar to a P51 type mount. The four tubes that make up
each beam and their support tubes must lie in a flat plane.

What ever you do... make a 1/4 scale balsa model of the
mount first. You can learn volumes
about space frames by making models.

Paul Lamar

Paul, I like the space frame, but I have a
question about the model you show. It appears
that the tube you have between the junction
of the down tube from the rear would pass
directly through the oil pan. I many be wrong
but I look at models all the time and it doesn't
look quite right. I'm sure the lateral brace
could also pass behind the engine.
Bill Jepson

I don't completely understand what you are saying Bill.
It goes along side the pan. You can also widen the beam to get
more pan clearance if you wish.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.