Subject: Can you ID this 13B?
From: ACRE
Date: 3/26/2004, 1:38 PM


Paul,

I have had email discussions with Jerry Hey about mounts for the MII
recently and you are correct- his mounts are reasonably priced.  He
also made a mount recently for a guy in Florida for an MII using a
rotary, but did not have photos.

Bob Lemings

Here is one of Jerry's mounts for Bob Whites BD4. You don't have to
use the motor plate. The one shown is rather expensive. You could use
a Schertz beam instead. Here too is a similar mount built by Bill
Schertz. Also a minor improvement to the Schertz Beam by me. Bill did
some extensive stress analysis on his beam.

Paul Lamar


Just for the record, if I were doing it over, I would go with the Shertz
beam also.  The motor mount plate is a beautiful piece of work, but
besides the cost it causes more interference problems than the Shertz
beam.  At one point I had decided to simplify my life by using the
stock exhaust manifold, and purchased one on ebay.  I couldn't use it
because it runs into the MM plate.

I would also like to separate the gear reduction installation job from
the engine mount.

Bob White

Does the Schertz beam recommendation apply in a pusher configuration as well,
with a similar (but modified for the different firewall) mount there? The only
commercial product that I know of for this is the Conversion Concepts mount,
which I know Paul had some choice words about. But this already has a
horizontal beam across both front and rear mount points so it seems like a
Schertz beam is not required. Should this be added as an extra piece to
eliminate the need for the motor mount plate they have? If so, does a spacer
or similar beam needed to be added to the firewall side?

Regards,
Chad

Sure. It will work on a pusher as well. it is a LOT lighter weight and 
a LOT ($500) cheaper than a machined plate of aluminum.

At $3 a pound a 18 by 14 by 2 inch chunk of aluminum will weigh 50 pounds.
At $3 a pound that is $150 just for the raw material cost. Then you have
a $30,000 to $50,000 NC mill to pay for.

Frankly it is a dumb idea unless you need to make payments on your NC mill :) 

The rear mount (pusher front) can be real simple. Just a strut down or up from the
firewall. Little or no load on it.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.