Subject: Can you ID this 13B?
From: ACRE
Date: 3/26/2004, 10:27 AM


Paul,

I have had email discussions with Jerry Hey about mounts for the MII
recently and you are correct- his mounts are reasonably priced.  He
also made a mount recently for a guy in Florida for an MII using a
rotary, but did not have photos.

Bob Lemings

Here is one of Jerry's mounts for Bob Whites BD4. You don't have to
use the motor plate. The one shown is rather expensive. You could use
a Schertz beam instead. Here too is a similar mount built by Bill
Schertz. Also a minor improvement to the Schertz Beam by me. Bill did
some extensive stress analysis on his beam.

Paul Lamar

Just for the record, if I were doing it over, I would go with the Shertz
beam also.  The motor mount plate is a beautiful piece of work, but
besides the cost it causes more interference problems than the Shertz
beam.  At one point I had decided to simplify my life by using the
stock exhaust manifold, and purchased one on ebay.  I couldn't use it
because it runs into the MM plate.

I would also like to separate the gear reduction installation job from
the engine mount.

Bob White

- - - - - - -
http://www.bob-white.com
N93BD - Rotary Powered BD-4


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.