Subject: 13B Turbo II mount for Mustang II
From: ACRE
Date: 3/27/2004, 11:14 AM


Hello Jerry-

I'm told you have produced 13B motor mounts for the Mustang II in the
past.  Is this correct?

We are looking for a supplier for our Mustang II project.  We'd
appreciate pricing & lead time info, if this is something you can
provide.  Photos of prior MII mount(s) would be great -- since we're
installing a turbo, any mount we get must not cause conflicts.  A
Shertz-beam type of design would be great.

Regards,

Mark Supinski & Mark Precious


-Hi Mark,   I have a fixture which can be adapted to any aircraft.   I
have never built an engine mount for the Mustang II and I have never
built a Shertz beam.   All my rotary engine mounts thus far have
utilized the motor mount plate.  I am interested in building a Shertz
beam and will be corresponding with Paul about that later today.  In
fact I will cc this to him.   If he will supply a drawing of the
Shertz beam Mustang II engine mount,  I will build it.

  Are the engine mount attach points on the firewall already in place?
If so,  you will have to supply a template so I can match them exactly.
  If they are not yet in place, it would be prudent to  hold off until
you have the engine mount in hand.

   Jerry

J-Wind Designs
TIG and Machine
Light Fabrication
260-799-4507

Ok Jerry Here it is.

Bill did a an extensive job of engineering on this.
The spread sheets shows different ways of making it.

Paul Lamar

Here are some more suggestions Jerry. Use the beam style mount and it will give
more clearance for turbos or cowl internal mufflers.
Also add these clips made from .065 4130 sheet bent up into an angle.
That stiffens the beam for prop gyro loads.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.