I just discovered that a Ford injector will physically interchange
with a Mazda/Nippon Denso and Lucas injectors if you remove the little

plastic

tip on the nozzle end. The fuel rail will have to be different however.
Ford injectors are much lower cost than Nippon Denso.
They can also be had in higher flows as I recall.

Paul Lamar

Paul,
That's exactly what I used on my 3-rotor.  Bought a set of 8 of the

42lb/hr

units from
ebay for about the price of having my old ones cleaned.  The 42lb/hr

flow

is very
close to the 460cc rating that Mazda uses in the n/a 13B's.

Mark

8 injectors?   Why 8?  Doesn't the 20B need 3 (or 6)?
[no signature]

No, my 20B is set up with two injectors/rotor. I purchased them off an ebay
auction intended for Mustang owners, hence a set of 8.  I figured that the
price was right (compared to Mazda prices) and it would be handy to have
a couple of extras in case one goes bad.

Mark S.

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.