Subject: Deta couple plate aluminum steel end housings.
From: ACRE
Date: 3/28/2004, 9:55 PM


Ken Welter wrote:

  Have you ever looked into Deta couple plate ?

   It is steel on one side and aluminum on the other side and is used
in boat and ship building to connect an aluminum cabin to a steel
hull.
  They weld a strip of this to the deck and then weld an aluminum cabin to it.

  They make the plate by laying an aluminum plate on top of a steel
plate and then packing explosives on top of it and then take a cat
and bury it with dirt and light it off and they end up with one plate.

  It may be what we need for end housings.

   Ken

many snips...

http://www.dynamicmaterials.com/clad/docs/HTML/nobelclad_technical_bulletin_nt200.htm

Sounds like the steel wear surface can be very thin. Perhaps on the order of .010 inches.
This should cut both the cost of the process and the weight of the end housing.

Paul Lamar

I just had an idea. You could make a thin flat aluminum/steel  bimetallic material using
DetaCouple and furnace braze it to the cast aluminum end housing at 1100 F for a very 
strong bond indeed. In fact this process would work for the rotor housing as well.
This could be a very low cost manufacturing method if automated.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.