Subject: End housing (aluminum silicate)
From: ACRE
Date: 3/28/2004, 1:09 AM


Any merit to using aluminum silicate ceramic or ceramic/aluminum sandwich
for the end housings?  The mechanicals aren't bad at all and it's not that
expensive.  With a post-machining cure it becomes quite hard. I'm just
spouting, I haven't run the numbers yet.

Mike

Mike, This is a good idea.  We did mention this in the
side plate threads in the past. Honda used a CERMET
for the cylinder liners in their RC 45 and they work great.
The problem is production costs for any new process.
I believe these materials also require diamond grinding
for finishing.  They have a uniform expansion which would
be good. The cermet materials are also good for heat so
RX-8 Renesis ports would work with them as well. They
aren't as light as aluminum, but are only about 1/2 the
weight of steel or iron. We shouldn't ignore this technology.
Bill Jepson


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.