Subject: End housing (aluminum silicate)
From: ACRE
Date: 3/29/2004, 8:22 PM


"Decker, Michael" wrote:

What is the finish spec. on the sealing surface of the
end housing?  (So I
can ask my machinist about it.)


Michael,
 The concern is sealing, when using a hard surface you need a smoother
surface. Many of the rebuilders use blanchard ground surfaces. This would
give a surface typically around 32 micro inches. (a fine grind) Any cermet
surface would need to be that good or better. The surface wears the seals,
rather than the seals wearing the surface. I would suggest a 16 finish,
which is pretty much polished.
Bill Jepson

"Decker, Michael" wrote:

Good info, thanks Bill.

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.