Subject: Cog Belt 3 rotor RX8
From: ACRE
Date: 4/2/2004, 12:10 PM



   You will like the new coot Paul as it has lots of leg and head room
for your big frame.
   I have lifted off at a gross weight of 3100 in the new coot and
that ain't toped out yet.

   Ken


As I always say we have just scratched the surface of the capabilities
of the 13B so far.

BTW I was driving in from Las Vegas this morning and I came up with the
perfect
solution for the lack of torque in the RX8. Quite simple. Just install
an all aluminum
side port three rotor. 50% more torque from the current 160 foot pounds
to 240 foot
pounds.  If I get to talk to the engineers in Japan next week I am going
to
suggest it. After all the competition is using all aluminum 3.5 L and
up piston engines. A 3 rotor would be 3.9 L and have 375 HP with the
same level of tune as the current RX8 2 rotor. The weight would be
nearly
the same as the current RX8. That ought to devastate the competition :)

So the 3 rotor  RX8 would go 200 MPH so what? :)

Paul Lamar

Alex Madsen wrote:

What would be required to crate a custom 3 rotor Renesis? Naturally one
would need to create a new eccentric shaft. Could one just use 2 middle
housings in the assembly? It seems to me one may run in to trouble with
the planetary gears and balancing the shaft. How are the lobes on the
20b orientated? I have not had the opportunity to dissect a rotary
engine yet so I have no idea what is possible.

Alex


A custom three rotor intermediate housing with side exhaust ports.
Not easy to do. Balance or planetary gears are not problems.

I think the stock three rotor shaft might work. Lobes are 120 degrees
apart.

In some ways it is easier to make a four rotor with a custom shaft.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.