MRE-FB wrote:
Dear Paul,
I have been following with great interest the thread on the
manufacturing processes to adopt for the rotor housing liner and to make
Al side-housings. Some very interesting ideas have been flying around.
So, I put a consultant of ours on the case with a mission to evaluate
technically and cost-wise the various technologies potentially
available.
BTW, this consultant is an interesting guy, he was in the '70s the
technical manager of the Comotor plant, the NSU-Citroën joint venture to
manufacture rotary engines. So, to my knowledge, he is the only
non-Mazda person in the world to have set-up a dedicated rotary engine
plant, manufactured the engine industrially... and later decommissioned
the plant! A few liens on Comotor:
http://www.monito.com/wankel/citroen.html
http://www.rotaryaviation.com/rotaryhistory.htm#Part%204
http://hem1.passagen.se/chapron/birotor.htm
http://www.der-wankelmotor.de/Flugzeuge/Citroen-Helicopter/citroen-helic
opter.html (in German but with good pictures of the Citroën
rotary-powered helicopter)
In return for publishing an abstract of his report on the newsletter,
would you do me a favor?
There is one technology that we know works for the epitrochoid liner:
Mazda's! During your visit, would you be kind enough to try to find
out:
a). Whether Mazda is casting the rotor housings in-house or if they
subcontract it to an outside foundry and which one.
b) If they procure the foundry parts, whether the technology (and maybe
tooling) necessary to cast aluminum around the pre-formed steel insert
is theirs or belongs to the sub-contractor.
Oh! We just got our first 4 rotor-housings back from machining, 2 of
them are going next week to have the epitrochoid plasma-sprayed
(Iron/Iron oxide) and the other 2 to have it NiCaSil-treated, for
testing these 2 possibilities. After Sun'n Fun, we'll beat the hell out
of them and see what gives. I attach 2 pictures, one of a Mistral
casing compared to a Mazda one to show some of the differences and
another one of ME housings viewed from different angles. Do you have
suggestions on the seal materials we should use?
Best regards,
Francois Badoux
OK. Creavey teflon encapsulated silicone O rings. Best we have found so far.
Good to 500 F.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.