Subject: O-Ring Housing repair
From: ACRE
Date: 4/2/2004, 12:23 PM


Bob Perkinson wrote:

Attached is a picture of the Center housing of an 87 13B that I
have,
as you can see the combustion o-ring housing is broken off.  Has
anyone successfully repaired the outer wall of the combustion O-ring
housing?  Can this even be repaired?

Bob Perkinson
RV9A

Common problem for that year engine. Yes somebody has repaired them by
brazing as I recall. I personally would not consider the repair safe
for
aircraft use however. These housing are interchangeably from year to
year somewhat. I would get another end housing from an 89 or latter. I
think Mazda had a quality control problem or the design did not allow
enough excess meat for minor core shifts. They fixed this problem in
later years by modifying the casting patterns I think.

Paul Lamar

Here is how I fixed one by making a steel insert. I have a couple
hundred hours on it. Use at your own risk.

Chuck Dunlap

"Brian D. Cain" wrote:

Wow, very creative Chuck. :)

B
__________________
Brian D. Cain -/- Grand Prairie, TX -/- bdc196@killspam.comcast.net
bdc@killspam.teamfc3s.org
BDC Motorsports - Performance 13B Engines, Haltech EFI tuning, Etc.
MSN bdc196@killspam.hotmail.com, Yahoo! bdc196, AOL Symajhi, ICQ# 1733105
http://bdc.cyberosity.com -/- http://groups.yahoo.com/group/HaltechSupport


Bob,
My '89 13B junkyard engine had the same failure.  I decided to try to see if I
could save the side housing.  I repaired it by brazing up the broken out
section.  I have not reassembled the engine and ran it to see if the repair
worked.  It appears that it would, but who knows?  And would I fly with this
fix?  I don't think so.  I might be tempted to use it in a car though.

Mark S.

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.