Bob Perkinson wrote:
Attached is a picture of the Center housing of an 87 13B that I have,
as you can see the combustion o-ring housing is broken off. Has
anyone successfully repaired the outer wall of the combustion O-ring
housing? Can this even be repaired?
Bob Perkinson
RV9A
Common problem for that year engine. Yes somebody has repaired them by
brazing as I recall. I personally would not consider the repair safe for
aircraft use however. These housing are interchangeably from year to
year somewhat. I would get another end housing from an 89 or latter. I
think Mazda had a quality control problem or the design did not allow
enough excess meat for minor core shifts. They fixed this problem in
later years by modifying the casting patterns I think.
Paul Lamar
Here is how I fixed one by making a steel insert. I have a couple
hundred hours on it. Use at your own risk.
Chuck Dunlap
"Brian D. Cain" wrote:
Wow, very creative Chuck. :)
B
__________________
Brian D. Cain -/- Grand Prairie, TX -/- bdc196@killspam.comcast.net
bdc@killspam.teamfc3s.org
BDC Motorsports - Performance 13B Engines, Haltech EFI tuning, Etc.
MSN bdc196@killspam.hotmail.com, Yahoo! bdc196, AOL Symajhi, ICQ# 1733105
http://bdc.cyberosity.com -/- http://groups.yahoo.com/group/HaltechSupport
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.