> >>>Michael McGee wrote:
> >>>
> >>>>Doing some dreaming..
> >>>>
> >>>>What do you guys think of the viability of a front cover cast into the form
> >>>>of a standard Lycoming dynafocal-1 mount?
> >>>>
> >>>>A loose collection of my thoughts so far:
> >>>>
> >>>>I think it would sell well enough to get the price under $500 for the
> >>>>kit. I was bs-ing with the local rotary engine builder the other day and
> >>>>he showed me a very nice third-gen oil pan that was cast as a replacement
> >>>>for the stamped steel original. The reason behind the pan is another story
> >>>>but the casting work looked great (from this engineer/ non-casting expert's
> >>>>perspective anyway). He insists that he has a casting guy that is capable
> >>>>of making what we need if I can get him a proto type part.
> The idea behind this is fairly sound since it would eliminate some of the
> engineering rotary conversion folks go through. You need to control the price
> as much as possible to keep it attractive. Would this be an addition to a
> traditional dynafocal mount that basically adapts the Mazda engine to it, or a
> dynafocal-like mount with multiple pieces, that could support either engine?
> Would your front plate be enough to mount the engine with, or would we still
> need to fabricate additional support members to the far side of the engine?
>
> Brock's Lycoming mount for the Cozy is $625. If your item is an adapter to a
> dynafocal, it would cost me, as a builder, $1125 for this combination. The
> Conversion Concepts mount (if you set aside Paul's issues with it for the time
> being) is $1098. That's not unattractive for a mount that does more (by
> allowing the use of either engine, making the plane easier to sell, or making
> retrofits easier). However, if the cost climbed much above your estimate or if
> additional engineering was still required, it would be harder to compete.
>
> With respect to the water pump, should I tease Paul and suggest an electric
> water pump? =)
>
> How serious are you about creating this? If you started and then changed your
> mind after making a few, would you publish the specifications and a
> dimensional drawing? Knowing that a part will be available when I'm ready to
> actually mount the engine is one of the factors a builder has to consider.
>
> Regards,
> Chad
Have you considered CG issues??? When I looked at this a couple of years ago I considered building an engine adapter to fit the standard conical
mount (for a RV-4) but determined that the CG of the engine would be moved forward a significant amount. I don't remember the exact amount, but I
think that it was about 2 inches.
Ken Powell
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.