Subject: removal of the pilot bearing
From: ACRE
Date: 4/22/2004, 3:10 PM


Many years ago while working on my brother's race car, the following system was used, and the removal of the pilot bearing was a piece of cake.

1.  Fill the pilot bearing hole with grease.
2.  Use a dowel or other similar under-sized shaft and gently tap it into the pilot bearing hole.
3.  This forces the grease behind the pilot bearing, and through hydraulic principles, will ease the bearing right out of its hole.
4.  As the bearing comes out, you will have to remove the dowel and replenish the grease.
5.  No pulling, yanking, etc., it should fall right into your hand.

Joe Graham

BTW Joe I got that literature on the Detaclad. Thanks.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.