Jerry Hey wrote:
Paul, I have turned over the P Port throttle body to a machinist who I
believe will do good job. I expect to have the prototype in my hands
by the end of next week. I will post photos for review by the members
of this list. I am pleased with the price which is less than $200.00
per copy. If this becomes popular, the price will come down. BTW
there is no expensive CNC programming involved. Also, there will be no
problem boring the housings. The only fixture required for that
process is a large angle plate.
In the meantime, what, if any, modifications are recommended for the
exhaust port? Remember that I am starting out MILD. My first goal
is to spin a big three blade that was too much for an 0-360 Lyc.
claimed to produce 200 hp. Also, I am rpm limited because I have
the 2:17 . If this turns out well, we can change drives and increase
the size of the ports. Jim Mederer told me to keep the ports small,
if running around 6000
rpm. I put enough meat into the insert that radical size and timing
can be achieved with a die grinder. The material is there to copy the
LeMans ports.... if someone is so bold. How much power would a big p
port turning 8000 rpm develop?
Still to be figured out is how to plug four injectors into the
runners. A year or so ago, you posted a Rhino drawing showing how it
would look using a casting you would produce. I hope it is still a
possibility.
I am so pleased to be rolling on this after being stalled for so long.
For those new to the list, I started working on this nearly two years
ago but got derailed by a move and the need to build a new shop. The
P port is a weight and space saver, and it delivers turbo power
without the fuss. There is nothing to break.
On another subject, I think the Shertz Beam engine mount has the
potential to cut the price by 50 per cent over the motor mount plate
and other systems now being used. That should have got my attention.
I was so focused on what I was doing at the time, I hardly noticed
it when Bill built the original. My wife claims my tunnel vision is,
at times, damn near blindness. Jerry
Richard wrote:
Hi Jerry,
I am glad to see someone doing a p-port installation. A p-port engine would
be the first to benefit from the work I am doing on the one-rotor. I am
talking about the light weight side housings. Without having to worry about
sealing side ports. With the design I am using now, a 13B engine would be
about 45-50lb lighter.
With Paul's help in getting castings going, my final prototypes could run on
the test stand in a few month. From there on it should be possible to have
the first intermediate housing in another six month.
I certainly would like to look at you or a possible guinea pig, but not
before I fly the one-rotor in my airplane.
On your power estimate, if you look at the MAZDA LeMans curve and
extrapolate you will be looking at 150hp per rotor at 7500RPM. This is
certainly another vote for the 2.85 gear ratio. And this would give you
shorter intake runners too. This is off curse N-A.
Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/
At this rate it might be a year before I get my NC mill going.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.